beautypg.com

View comm settings, Figure 14. sequence for recalling an image – Extron Electronics Annotator User Guide User Manual

Page 29

background image

To recall an image:

1.

Press and release the Capture/Recall button. The LCD displays “IMAGE RECALL”.

2.

Press Next to enter the Recall menu. The LCD displays “Recall: ”.
Use either Adjust knob to scroll through the saved images, to the desired image.

3.

Press Next to recall the image. The LCD displays “Recalling image Please wait” while
the image is downloaded to the display. When the image is fully downloaded, the
LCD displays the name of the image and “Recalled”, (for example, “IMG05.bmp
Recalled”). The recalled image is displayed on the active display. Press Next to exit the
Image Recall menu.

Press and
release

CAPTURE/

RECALL

IMAGE

RECALL

Step

1

LCD screen displays

UNDO/

CLEAR

ADJUST

Rotate either
Adjust knob.

Recall:

MENU

NEXT

Press

LCD screen displays

Recall:

IMG05.BMP

LCD screen displays

Recalling Image

Please wait

MENU

NEXT

Press

LCD screen displays

then

Step

2

IMG05.BMP

Recalled

Step

3

Figure 14.

Sequence for Recalling an Image

To remove an image from the display:

1.

Press and release the Capture/Recall button. The LCD displays “IMAGE RECALL”.

2.

Press Next. The LCD displays “Recall: ”.

3.

With “Recall: ” displayed, press Next. The current image is removed from the
display, but not from the Annotator memory. To recall the image follow the steps
described in the “To recall an image” section on this page.

View Comm Settings

Within this menu the current IP settings are only viewable. To make any adjustments the
“hidden” Edit Comm Settings menu must be accessed (see below).

1.

Press Next to go through each sublevel to view the following: Serial port (baud rate
and communication type), MAC address (cannot be changed), DHCP status (on or off),
IP address, subnet mask, and gateway address.

2.

Press Next or Menu to return to the View Comm Settings menu.

To enter the “hidden” Edit Comms Settings menu, press and hold in the Detail and
Color/Tint buttons simultaneously, and then press the Next button. The Edit Comms
Settings menu appears.

Annotator • Operation

23