Extron Electronics Annotator User Guide - Manual (Page 34)

Input 1
Input 6
Input 5
Input 4
Input 3
Input 2
Input 64
Output 1 Input 3
Output 6 Input 3
Output 5
Output 4
Output 3
Output 2 Input 3
Annotator #1
Annotator #6
(optional)
Annotator #2
(optional)
Output to display
Output to display
Output to display
Output 4
Output 3
Matrix
Switcher
Figure 17. Multiple Annotators Connected to a Matrix Switcher
3. On the Annotator, configure the input as follows:
a. Switch to input 3 on the Annotator.
b. Set the following input sampling settings as needed: signal type, horizontal and
vertical start, pixel phase, total pixels, active pixels, and active lines.
NOTE: Do not use the auto detect setting for the input type when using
input presets.
c. Set the following picture controls as needed: size, position, color, tint, brightness,
contrast, and detail.
d. Save the adjusted settings as input preset 1. See the “SIS Communication and
Control” section , for the SIS commands to save the preset.
NOTE: Each input preset must be saved with the same number as the input
on the matrix switcher. For example, input 24 on the matrix will be
associated with the input preset 24 on the Annotator.
e. Repeat steps 2 and 3 for each matrix input that is used on the Annotator.
4. Synchronize the Annotator to the matrix switcher as follows:
a. Open the control program (SPPCP) and connect to the Annotator.
NOTE: Connection must be via IP (not RS-232).
b. From the Tools menu, select Sync to Matrix Switcher... . The Sync to
Matrix Switcher window opens.
c. In the IP Address field, enter the IP address for the matrix switcher.
Annotator • Operation 28