Extron Electronics Annotator User Guide - Manual (Page 89)

Scaler Settings page
Access the Scaler Settings page by clicking the Scaler Settings link on the sidebar
menu on the Configuration page.
Figure 47. Scaler Settings Page
The Scaler Settings page displays Input Configuration settings (input signal format,
auto image and film mode status), Output Configuration settings (resolution and refresh
rates, output sync format, and polarity), Advanced Configuration settings (RGB delay, test
pattern selection, auto memory status, aspect ratio mode, switch effect, MTP
pre-peaking settings, and EDID resolution and refresh rates), and On Screen Display
settings. Any settings can be changed and the unit updated to the new settings. The page
updates itself periodically to reflect the latest status of the Annotator components. If a
variable changes, the display shows the change in status the next time it updates.
Input configuration
For each of the seven inputs, the input format can be changed by clicking on the drop-
down list arrow and selecting the appropriate signal type:
NOTE: Selecting Auto Detect allows the device to automatically set the input to
the appropriate signal format.
Input 1: RGB, YUVp/HDTV, Auto Detect
Input 2: RGB, YUVp/HDTV, Auto Detect
Input 3: RGB, YUVp/HDTV, RGBcvS, YUVi, S-video, Composite, Auto Detect
Input 4: YUVi, S-video, Composite, Auto Detect
Input 5: S-video, composite, Auto Detect
Input 6: DVI
Input 7: SDI, HD-SDI, Auto Detect
For each input Auto Image can be set on or off.
For each of the inputs film mode can be enabled or disabled.
NOTE: Film mode processing helps maximize image detail and sharpness for NTSC,
PAL, and HDTV 1080i sources that originated from film.
Annotator • HTML Operation 83