GE Industrial Solutions A Series Lighting Control Panelboards Programmer User Guide - Manual (Page 53)

A Series ® Lighting Controller LCD Programmer
Chapter 13 – Event Menu
49
3. Press OK to display the current buffer size:
4. To edit the buffer press OK:
5. Use the numeric keypad or arrow keys to enter the
new buffer size.
6. Press OK to display Device Status. Device status
consists of dead battery, reset device, device
offline, or undervoltage.
7. Do either of the following:
• Use the arrow keys to scroll to the next category
if no change is required.
• To edit press OK . Press the arrow key to adjust
Yes or No, and then press OK to accept the
change.
8. The Time Change display appears next:
9. Do either of the following:
• Use the arrow keys to scroll to the next category
if no change is required.
• To edit press OK . Press the arrow key to adjust
Yes or No and then press O K to accept the
change.
1 0 . The Lighting Alarms display is next. Lighting
alarms consists of breaker trip and command
failure.
11. Do either of the following:
• Use the arrow keys to scroll to the next category
if no change is required.
• To edit press OK . Press the arrow key to adjust
Yes or No and then press O K to accept the
change.
1 2 . The Lighting Status display appears. Lighting
status consists of status on and status off.
13. Do either of the following:
• Use the arrow keys to scroll to the next category
if no change is required.
• To edit press OK . Press the arrow key to adjust
Yes or No and then press O K to accept the
change.
Flashing