Groups, A series – GE Industrial Solutions A Series Lighting Control Panelboards Programmer User Guide User Manual
Page 36
A Series
®
Lighting Controller Programmer
Chapter 8 – Lighting Group Menu
32
10.
Press
OK
to edit the Override time.
11.
Use the arrow keys or the number keypad to adjust
the time, up to 240 minutes:
12.
Press
OK
to accept the changes.
13.
Press
ESC
to return to the Override submenu.
Groups
The Groups function is used for common areas so that
lights stay on when any one of the nested Lighting
Groups is on. Lights stay on until all the nested groups
are OFF and the off time delay times out. Note that if a
Schedule, Photocell, Astro, or Override turns the group
on, then the group remains on.
Viewing a Group
1.
Navigate to the Lighting Group menu.
2.
Press
OK
to display the first Lighting Group and
use the arrow keys to navigate to the desired
group.
3.
Press
OK
and AUTO starts to flash:
4.
Press the
Fn
key and press the down arrow key five
times to reach the Groups submenu:
5.
Press
OK
to display the Group Off time:
6.
Use the arrow keys to continue to scroll and view
all available groups.
Changing the Group Off Time
Use the following procedure to adjust the group Off
time.
1.
Navigate to the Groups submenu as in the previous
procedure.
2.
Press
OK
to display the Group Off time.
3.
Press
OK
to edit the Group Off Time:
4.
Use the number keys to adjust the Group Off time,
and then press
OK
.
Flashing
Flashing
Flashing
Flashing