EVS XTnano Version 11.02 - July 2013 Operation Manual - Manual (Page 88)

How to Move an Element within a Playlist
Note
You can only move elements within a playlist if you are in PGM/PRV mode.
To move a playlist element within a playlist using the Remote Panel, proceed as follows:
1. While you are in Playlist Edit mode, scroll within the playlist to the clip that needs to
be moved.
2. Select Delete from the Playlist Edit menu. The clip is sent to the clipboard and loaded
on the PRV channel.
3. Scroll to the location in the playlist where you want to insert the clip.
Remember that the position where the clip is inserted will depend on the value of the
Insert in playlist parameter in the Operational Setup menu (p3.1 F6), that is to say before
or after the selected playlist element.
4. Press TAKE or Insert on the Remote Panel to insert the clip from the clipboard at the
requested location.
The playlist element is inserted at the requested location.
If the playlist element has been trimmed before being moved, the element will be
reinserted in the new position with the new guardbands.
5.6.3. Browsing Within a Playlist
Introduction
You can browse within a playlist in different ways in the Remote Panel:
• Browse through the content of each clip in the playlist.
• Browse quickly by jumping to the first field of each clip in the playlist.
Browsing Through a Playlist
When you load a playlist, the default playlist mode allows you to scroll up and down
through all the playlist elements.
80 5. Playlist Management
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013