EVS XTnano Version 11.02 - July 2013 Operation Manual - Manual (Page 76)

How to Set the Current Playlist
In the Remote Panel Interface
To set the current playlist, proceed as follows:
1. Press SHIFT+Page+F_ key to select the page in which the desired playlist is located.
2. Press SHIFT+F10 to select the playlist bank.
3. Press F_ key to select the desired playlist.
4. Press ENTER to confirm.
To load the current playlist, continue as follows:
5. Press PLST to load the current playlist on a player channel (it cannot be empty).
To exit the playlist mode:
6. Press the RECORD key to return to E2E mode.
Notes:
• If the new playlist is not empty, it is automatically loaded on the PGM (in PGM/PRV
mode) and it becomes the current playlist.
• If the new playlist is empty, the system will ask you whether you want to copy the
current playlist at this new location.
Note
Page 1 contains playlists 10 to 19, Page 2 contains playlists 20 to 29, and so on.
In the VGA Interface
To set the current playlist, proceed as follows:
1. From the clip screen, press END to access the playlist bank.
2. Press DOWN ARROW to select the playlist that you want to define as the current
playlist.
3. Press ENTER on the selected playlist to set it as the current playlist.
68 5. Playlist Management
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013