EVS XTnano Version 11.02 - July 2013 Operation Manual - Manual (Page 72)

Add cut
The Add cut function (SHIFT+D key) allows the operator to split an existing clip into two
independent clips at a selected point. Both resulting clips are duplicates of the original one
with additional short-in and short-out points added at the split point.
5.3.3. Functions in Playlist Playout Mode
Once the playlist is cued and ready to roll, the menu below is displayed on the Remote
LCD. This menu gives the operator the ability to manipulate the playlist while it is playing.
The duration displayed in the top right corner of the LCD screen in Playlist Playout mode
is the remaining duration until the end of the playlist.
PL11 LSM 04 Albert LOC LEFT=00:00:02:22
111A Clipname012 00:00:29 Unk W00:10
112B/03 Clipname456 00:53:29 Unk M00:10
112B Clipname891 00:53:29 Unk M00:10
Film FX Next Skip Edit
Film FX
Selecting this function will create a film style effect during the playout of the playlist by
repeating one field every two fields. Please note that the audio is also affected by this
effect, making it unusable and therefore, muted. This mode is deactivated when exiting a
playlist.
Next
While the playlist is rolling on air, selecting the Next function will start the transition of the
next clip with the transition effect listed on the playlist. This can be used if a clip is running
too long and it is necessary to shorten up the playing time.
Skip
While the playlist is rolling, the next clip in the sequence is always displayed on the PRV
screen. The Skip function allows the operator to discard clips before they go on-air. The
clip that will be «skipped» is the one displayed on the PRV screen. This function does not
remove the clip from the playlist, but it simply allows it to be skipped during playback.
Edit
Selecting the Edit function gets the user back to the Playlist Edit mode.
64 5. Playlist Management
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013