EVS XTnano Version 11.02 - July 2013 Operation Manual - Manual (Page 60)

Deleting All Unprotected Clips in a Bank
To delete all unprotected clips stored on a given bank, proceed as follows:
1. Select the page where the bank that you wish to clear of all unprotected clips is
stored.
2. Press CLEAR, SHIFT , then the F_ key corresponding to the bank.
The following confirmation message is displayed:
Caution:
This will delete all unprotected clips
stored on bank X
[Menu] : Cancel [Enter] : Confirm
3. Press ENTER to confirm the unprotected clips deletion on the selected bank.
Deleting All Unprotected Clips
You can delete all unprotected clips in one operation using the Clear All Clips command.
The following clips will not be deleted:
• Clips stored on protected pages as defined in the Setup menu.
• Clips protected by another protocol.
• Clips included in playlists.
To clear all unprotected clips, proceed as follows:
1. Press SHIFT+MENU to go to the main menu.
2. Press F7 (Clear All Clips command).
3. When the confirmation message is displayed, press ENTER to confirm the
unprotected clips deletion.
4. A message is displayed on the video monitor to notify the operation completion.
Warning
The Clear All Clips command is different from the Clear Video Disks
command available in the Maintenance menu of EVS software.
• The Clear All Clips command deletes only the unprotected clips.
• The Clear Video Disks command in the Maintenance menu
definitively deletes all video and audio data from the disks, including
any clip stored in protected pages.
52 4. Clip Management
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013