EVS XTnano Version 11.02 - July 2013 Operation Manual - Manual (Page 30)

3.2.2. 1PGM+PRV Primary Menu Controls
Introduction
The primary menu in 1PGM+PRV mode, illustrated below, gives access to the functions
detailed in the following paragraphs:
Rst Cam Sync Prv
Cam A Cam B
CAM A / B / C / D
Rst Cam Sync Prv
Cam A Cam B
If PRV CTL is 'OFF', select the camera to assign to the PGM output. This camera key
will be highlighted in the menu.
If PRV CTL is 'ON', select the camera to assign to the PRV output. This camera key will
be highlighted in the menu.
Rst Cam
Rst Cam Sync Prv
Cam A Cam B
This function restores the position of cameras on the active channels: CAM A on PGM1,
CAM B on PRV.
Note
When a clip/playlist is loaded on a channel, switching back to Live mode will
recall the record train, which was last used on that output. This avoids too
frequent uses of the Rst Cam function.
Sync Prv
Rst Cam Sync Prv
Cam A Cam B
This option allows the user to synchronize the PRV with the timecode and speed of the
PGM output. This function is not available with remote record trains.
22 3. Control Modes
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013