EVS XTnano Version 11.02 - July 2013 Operation Manual - Manual (Page 20)

Function Key Use
F3 Not used.
F4 Not used.
F5: Char. On/Off Enables or disables the on-screen display (Timecode, Clip ID…)
on the output monitors.
F6: Exit Exits the Multicam software and returns to the EVS Menu.
F7: Clear all clips Clears all clips. All clips will be lost. A confirmation of this
command is required.
For more information to this action. "Deleting Clips" on page 51.
Note: This command is not similar to the Clear Video Disks from
the Maintenance menu. If you wish to refresh completely the
server, i.e. to clear all clips including the protected ones, you
need to use Clear Video Disks rather than Clear all clips.
F8: Stop Record Stops the record. The REC key will go off and the F8 function
key is now used to restart the record.
F9: Fill Playlist «Dump» feature which allows all clips to be «dumped» at the end
of the current playlist. This allows the operator to save all
material to tape, as a backup feature after a show is complete.
You can select in the Setup menu which camera angles have to
be included in the Fill Playlist function.
Make sure that the playlist you have selected is an empty one.
This function will append the clips at the end of an existing
playlist.
F0: Technical
setup Gives access to the technical setup menu.
Warning
In order to guarantee the validity of data and clips previously saved, it is advised
to properly exit the application by pressing ALT+Q and ENTER from the
keyboard, or F6 and then ENTER from the Remote Panel. Do not turn off the
system while the application is running.
2.3.2. Function of the Small Keys
MENU
This function allows the operator to gain access to the secondary menu.
SHIFT+MENU on the Remote gains access to the main menu.
Also used as an ESCAPE key to cancel some options and messages.
12 2. Working Interfaces
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013