EVS XTnano Version 11.02 - July 2013 Operation Manual - Manual (Page 34)

How to Enter the Multi-PGM Mode
To enter the Multi PGM mode, press B from the Main menu. This button is labeled
'1 PGM', or '2 PGM' according to your system configuration.
The Remote Panel will then display the following screen:
PGM1 CAM A *PGM2* CAM B
Aud.Met. PgmSpd PostRoll
Sw to IN Pref
P.1 B.1
PL 11: <
Msg:
Rst Cam Sync To
PGM 1 PGM 2
The LCD display is divided in two menus controlled by soft keys (A, B, C, D). To gain
access to the upper menu, press MENU from the Remote Panel.
3.3.2. Multi PGM Primary Menu Controls
Introduction
The primary menu in Multi PGM mode, illustrated below, gives access to the functions
detailed in the following paragraphs:
Rst Cam Sync To
PGM 1 PGM 2
Rst Cam
Rst Cam Sync To
PGM 1 PGM 2
This function restores the position of cameras on the active channels: CAM A on PGM 1,
CAM B on PGM 2, etc.
Note
When a clip/playlist is loaded on a channel, switching back to Live mode will
recall the record train, which was last used on that output. This avoids too
frequent uses of the Rst Cam function.
26 3. Control Modes
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013