ZyXEL Communications VDSL SWITCH VES-1616F-3X - Manual (Page 260)

Chapter 34 IEEE 802.1Q Tagged VLAN Commands
VES-1616F-3x Series User’s Guide
260
Example:
34.2 Global VLAN1Q Tagged VLAN Configuration Commands
This section shows you how to configure and monitor the IEEE 802.1Q Tagged VLAN.
34.2.1 GARP Status
Syntax:
show garp
This command shows the switch’s GARP timer settings, including the join, leave and leave all
timers.
An example is shown next.
34.2.2 GARP Timer
Syntax:
garp join leave leaveall
where
sysname(config)# vlan 3
sysname(config-vlan)# inactive
sysname# show garp
GARP Timer
------------------------
Join Timer = 200
Leave Timer = 600
Leave All Timer = 10000
sysname#
join = This sets the duration of the Join Period timer for GVRP in
milliseconds. Each port has a Join Period timer. The allowed Join
Time range is between 100 and 32767 milliseconds; the default is
200 milliseconds.
leave = This sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave
Time must be two times larger than Join Timer; the default is 600
milliseconds.
leaveall
= This sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave
All Timer must be larger than Leave Timer; the default is 10000
milliseconds.