ZyXEL Communications VDSL SWITCH VES-1616F-3X - Manual (Page 233)

Chapter 32 Introducing the Commands
VES-1616F-3x Series User’s Guide
233
32.11.4 interface Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
vlan-stacking Enables VLAN stacking on the
device.
13
Sets the service provider’s TP
(Tagged Protocol) ID.
13
vlan-type <802.1q|port-based> Specifies the VLAN type. 13
wfq Sets the switch to use Weight
Fair Queuing (WFQ) queuing.
13
fe-spq Sets the switch to use WFQ to
service all queues for the
Ethernet port.
13
Table 81 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION P
Table 82 interface port-channel Commands
COMMAND DESCRIPTION P
interface port-
channel
list>
Enables a port or a list of ports for
configuration.
13
bandwidth-
limit
Enables bandwidth control on the
port(s).
13
cir Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
13
egress Sets the maximum bandwidth allowed
for outgoing traffic on the port(s).
13
pir Sets the maximum bandwidth allowed
for incoming traffic on the port(s).
13
bpdu-control
discard|netwo
rk>
Sets how Bridge Protocol Data Units
(BPDUs) are used in STP port states.
13
broadcast-
limit
Enables broadcast storm control limit
on the switch.
13
Sets how many broadcast packets the
interface receives per second.
13
cable_diagnos
tics
Displays whether a cable is connected
to the port (good) or not (open).
13
diffserv Enables DiffServ settings on the
port(s).
13
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
13
Sets the interface DLF limit in packets
per second (pps).
13
egress set Sets the outgoing traffic port list for a
port-based VLAN.
13