ZyXEL Communications VDSL SWITCH VES-1616F-3X - Manual (Page 237)

Chapter 32 Introducing the Commands
VES-1616F-3x Series User’s Guide
237
32.11.6 vdsl-alarmprofile Commands
The following table lists the vdsl-alarmprofile commands in configuration mode.
group
start-address
end-address
Sets the multicast group range for
the MVR.
13
inactive Disables MVR settings. 13
mode Sets the MVR mode. 13
name Sets the MVR name for identification
purposes.
13
no group Disables all MVR group settings. 13
group Disables the specified MVR group
setting.
13
inactive Enables MVR. 13
receiver-port Disables the receiver port(s).
An MVR receiver port can only
receive multicast traffic in a multicast
VLAN
13
source-port Disables the source port(s).
An MVR source port can send and
receive multicast traffic in a multicast
VLAN
13
tagged
list>
Sets the port(s) to remove VLAN
tags.
13
receiver-port
list>
Sets the receiver port(s).
An MVR receiver port can only
receive multicast traffic in a multicast
VLAN
13
source-port
list>
Sets the source port(s).
An MVR source port can send and
receive multicast traffic in a multicast
VLAN
13
tagged Sets the port(s) to include VLAN
tags.
13
Table 83 mvr Commands (continued)
COMMAND DESCRIPTION P
Table 84 vdsl-alarmprofile Commands
COMMAND DESCRIPTION P
vdsl-
alarmprofile
Enters the VDSL alarm profile mode. 13
15minsESs Sets the number of Errored Seconds
(ES) allowed in any 15-minute
period. An alarm is triggered if this
number is exceeded.
13