ZyXEL Communications VDSL SWITCH VES-1616F-3X - Manual (Page 238)

Chapter 32 Introducing the Commands
VES-1616F-3x Series User’s Guide
238
32.11.7 vdsl-profile Commands
The following table lists the vdsl-profile commands in configuration mode.
15minsLoss Sets the number of Lost of Signal
(Los) errors allowed in any 15-minute
period. An alarm is triggered if this
number is exceeded.
13
15minsSESs Sets the number of Severely Errored
Seconds(SES) errors allowed in any
15-minute period. An alarm is
triggered if this number is exceeded.
13
exit Exits from this command mode. 13
initFailure Sets whether the device is to send an
initialization failure trap or not.
13
Table 84 vdsl-alarmprofile Commands (continued)
COMMAND DESCRIPTION P
Table 85 vdsl-profile Commands
COMMAND DESCRIPTION P
vdsl-profile Enters VDSL profile command
mode.
13
applicablestandard <2> Sets a standard your switch uses
for VDSL services.
2: ETSI
13
bandplan <2> Sets a VDSL band plan to use for
the line.
2: Bandplan998
13
compatiblemode <1..4> Sets the starting band of the
frequency range used by VDSL
services.
1: none
2: 640kHz
3: 1100kHz
4: 2200kHz
13
deployment <1..2> Specify a VDSL deployment
scenario.
1: FTTCab
2: FTTEx
13
exit Exits from the VDSL profile
mode.
13
hamband mask
<00000000000..00
000111100>
Sets the device not to transmit
signals in the pre-defined HAM
(Handheld Amateur Radio) radio
band(s).
13
interleavedelay ds <0..255> Specify maximum interleave
delay for downstream traffic in
the slow channel.
13
us <0..255> Specify maximum interleave
delay for upstream traffic in the
slow channel.
13