ZyXEL Communications VDSL SWITCH VES-1616F-3X - Manual (Page 214)

Chapter 32 Introducing the Commands
VES-1616F-3x Series User’s Guide
214
32.5.2 Detailed Command Information
Enter help to display detailed sub command and parameters.
Enter ? to display detailed help information about the sub commands and
parameters.
32.6 Changing the Password
This command is used to change the password for Enable mode. By default the same password
is used to enter the command line interface (CLI) and Enable and Config modes of the CLI.
The password you change with this command is required to enter Enable and Config modes of
the CLI.
Syntax:
password
where
sysname> ?
enable Turn on privileged commands
exit Exit from the EXEC
help Description of the interactive help system
history Show a list of previously run commands
logout Exit from the EXEC
ping Exec ping
show Show system information
ssh SSH client
traceroute Exec traceroute
sysname>
sysname> ping help
Commands available:
ping
<
[ in-band|out-of-band|vlan ]
[ size <0-1472> ]
[ -t ]
>
sysname>
sysname> ping ?
destination ip address
help Description of ping help
sysname>
= Specifies the new password (up to 32 alphanumeric
characters) users have to type in to enter Enable and Config
modes.