ZyXEL Communications VDSL SWITCH VES-1616F-3X - Manual (Page 236)

Chapter 32 Introducing the Commands
VES-1616F-3x Series User’s Guide
236
32.11.5 mvr Commands
The following table lists the mvr commands in configuration mode.
packet-format
ethernet-type
vlan priority
<0-7> inactive
Disables the protocol based VLAN. 13
pvid <1-4094> The default PVID is VLAN 1 for all
ports. Sets a PVID in the range 1 to
4094 for the specified interface.
13
qos priority <0-7> Sets the quality of service priority for
an interface.
13
speed-duplex
full|100-half|100-
full|1000-full>
Sets the duplex mode ( half or
full ) and speed ( 10 , 100 or 1000
Mbps) of the connection on the
interface. Selecting auto (auto-
negotiation) makes one port able to
negotiate with a peer automatically to
obtain the connection speed and
duplex mode that both ends support.
13
test Performs an interface loopback test. 13
vlan-stacking priority <0-7> Sets the priority of the specified port(s)
in VLAN stacking.
13
role
access | tunnel>
Sets the VLAN stacking port roles of
the specified port(s).
13
SPVID <1-4094> Sets the service provider VID of the
specified port(s).
13
vlan-trunking Enables VLAN Trunking on ports
connected to other switches or routers
(but not ports directly connected to
end users) to allow frames belonging
to unknown VLAN groups to pass
through the switch.
13
weight
...
Sets the queuing weight. 13
Table 82 interface port-channel Commands (continued)
COMMAND DESCRIPTION P
Table 83 mvr Commands
COMMAND DESCRIPTION P
mvr <1-
4094>
Enters the MVR (Multicast VLAN
Registration) configuration mode.
13
8021p-priority <0 - 7> Select a priority level (0-7) with which
the switch replaces the priority in
outgoing IGMP control packets
(belonging to this multicast VLAN).
13
exit Exist from the MVR configuration
mode.
13