ZyXEL Communications VDSL SWITCH VES-1616F-3X - Manual (Page 119)

Chapter 15 Port Authentication
VES-1616F-3x Series User’s Guide
119
15.2.2 Configuring RADIUS Server Settings
From the Port Authentication screen, click RADIUS to display the configuration screen as
shown.
Use this screen to configure RADIUS server settings. See
Section 15.1 on page 117 for
background information.
Figure 47 Port Authentication > RADIUS
The following table describes the labels in this screen.
Table 36 Port Authentication > RADIUS
LABEL DESCRIPTION
Authentication Server
IP Address Enter the IP address of the external RADIUS server in dotted decimal notation.
UDP Port The default port of the RADIUS server for authentication is 1812. You need not
change this value unless your network administrator instructs you to do so.
Shared Secret Specify a password (up to 32 alphanumeric characters) as the key to be shared
between the external RADIUS server and the switch. This key is not sent over the
network. This key must be the same on the external RADIUS server and the switch.
Apply Click Apply to save your changes back to the switch.
Cancel Click Cancel to begin configuring this screen afresh.