Events logged at level 1, Event log levels, Event log – TANDBERG Security Camera User Manual
Page 44
44
D14049.03
MAY 2008
Grey Headline (continued)
Events Logged at Level 1
Event
Description
Admin Session Finish
An administrator has logged off the system.
Admin Session Login Failure
An unsuccessful attempt has been made to log in as an administrator. This could be because either the username “admin” was not used, or an incorrect
password was entered (or both).
Admin Session Start
An administrator has logged onto the system.
Application Failed
The VCS application is out of service due to an unexpected failure.
Application Start
The VCS has started.
Further detail may be provided in the event data
Detail
field.
Call Answer Attempted
An attempt to answer a call has been made.
Call Attempted
A call has been attempted.
Call Bandwidth Changed
The bandwidth of a call has changed.
Call Connected
A call has been connected.
Call Disconnected
A call has been disconnected.
Call Rejected
A call has been rejected.
The
Reason
event parameter contains a textual representation of the H.225 additional cause code.
Decode Error
A syntax error was encountered when decoding a SIP or H.323 message.
Eventlog Cleared
An operator cleared the event log.
External Server Communication
Failure
Communication with an external server failed unexpectedly. The event detail data should differentiate between ‘no response’ and ‘request rejected’.
Servers concerned are:
DNS
•
LDAP servers
•
Neighbor Gatekeeper
•
NTP servers
•
Hardware Failure
There is an issue with the VCS hardware. If the problem persists, contact your TANDBERG support representative.
License Limit Reached
Licensing limits for a given feature have been reached.
The event detail field specifies the facility/limits concerned. Possible values for the detail field are:
Non Traversal Call Limit Reached
•
Traversal Call Limit Reached
•
Message Rejected
The VCS Authentication mode is set to On, and an endpoint has unsuccessfully attempted to send a message (such as a registration request) to the VCS.
This could be either because the endpoint has not supplied any authentication credentials, or because its credentials do not match those expected by the
VCS.
TANDBERG
VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Event Log