TANDBERG Security Camera - Manual (Page 152)

152
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Configuring the VCS as a Traversal Client
Overview
VCS Configuration > Zones • .
You will be taken to the Zones page.
Select New .
You will be taken to the Create Zone page.
xCommand ZoneAd • d
Name
Enter the name you wish to give to this zone.
The name acts as a unique identifier, allowing
you to distinguish between zones of the same
type.
Type
From the Type drop-down menu, select
TraversalClient .
Create Zone
Click here to create the zone. You will be taken
directly to the
Edit Zone page, where you can
configure the traversal client zone as required.
To enable your VCS to act as a traversal
client on behalf of its endpoints and neighbor
gatekeepers, you must create a connection
between it and a traversal server (e.g.
a TANDBERG VCS Expressway or Border
Controller).
You do this by adding a new traversal client
zone on the VCS client and configuring it with
the details of the traversal server.
You can create more than one traversal
client zone if you wish to connect to
multiple traversal servers.
Adding a New Traversal Client Zone