TANDBERG Security Camera - Manual (Page 223)

223
D14049.03
MAY 2008
Grey Headline (continued)
RouteAdd
Adds and configures a new route.
Address (r) :
Specifies an IP Address used in conjunction with the Prefix Length to determine the network to which this route applies.
PrefixLength (r) : <1..128>
Specifies the number of bits of the IP Address which must match when determining the network to which this route applies.
Gateway (r) :
Specifies the IP Address of the Gateway for this route.
Interface:
Specifies the LAN interface to use for this route. Auto: The VCS will select the most appropriate interface to use. Default: Auto
Example: xCommand RouteAdd Address: "10.13.8.0" PrefixLength: 32 Gateway: "192.44.0.1"
SubZoneAdd
Adds and configures a new subzone.
SubZoneName (r) :
Assigns a name to this subzone.
Address:
Specifies an IP Address used (in conjunction with the IP Prefix Length) to identify a subnet to be assigned to this subzone.
PrefixLength: <0..128>
Specifies the number of bits of the Subnet IP Address which must match for an IP Address to belong in this subzone.
TotalMode:
Determines whether the Default Subzone has a limit on the total bandwidth being used by its endpoints at any one time.
Total: <1..100000000>
Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to Limited).
PerCallInterMode:
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone.
PerCallInter: <1..100000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if Mode is set to Limited).
PerCallIntraMode:
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone.
PerCallIntra: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within this subzone (applies only if Mode is set to Limited).
Example: xCommand SubZoneAdd SubZoneName: "BranchOffice" Address: "10.13.0.0" PrefixLength: 28 TotalMode: Limited Total: 1024 PerCallInterMode:
Limited PerCallInter: 512 PerCallIntraMode: Limited PerCallIntra: 512
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Command Reference - xCommand