TANDBERG Security Camera - Manual (Page 181)

181
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Pattern Variable Reference
The VCS makes use of pattern matching in a
number of its features, namely
Allow Lists and
Deny Lists , pre-search Transforms and Zone
Transforms .
For each of these pattern matches, the VCS
allows you to use a variable that it will replace
with the current configuration value(s) before
the pattern is checked.
These variables can be used as either or both
of:
all or part of the pattern that is being •
searched for
all or part of the string that is replacing the
•
pattern that was found.
The variables can be used in all types of
patterns, i.e.
prefix , suffix , regex and exact .
The table opposite shows the strings that
are valid as variables, and the values they
represent.
String Equals current value(s) returned by... When used in a Match field When used in a Replace field
%ip% xConfiguration Ethernet 1 IP V4 Address
xConfiguration Ethernet 1 IP V6 Address
xConfiguration Ethernet 2 IP V4 Address
xConfiguration Ethernet 2 IP V6 Address Matches all IPv4 and IPv6 addresses
currently configured on the VCS. not applicable
%ipv4% xConfiguration Ethernet 1 IP V4 Address
xConfiguration Ethernet 2 IP V4 Address Matches the IPv4 addresses currently
configured on the VCS for LAN 1 and LAN 2. not applicable
%ipv4 _ 1% xConfiguration Ethernet 1 IP V4 Address Matches all IPv4 address currently
configured on the VCS for LAN 1. Replaces the string with the
LAN 1 IPv4 address.
%ipv4 _ 2% xConfiguration Ethernet 2 IP V4 Address Matches all IPv4 address currently
configured on the VCS for LAN 2. Replaces the string with the
LAN 2 IPv4 address.
%ipv6% xConfiguration Ethernet 1 IP V6 Address
xConfiguration Ethernet 2 IP V6 Address Matches the IPv6 addresses currently
configured on the VCS for LAN 1 and LAN 2. not applicable
%ipv6 _ 1% xConfiguration Ethernet 1 IP V6 Address Matches the IPv6 address currently
configured on the VCS for LAN 1. Replaces the string with the
LAN 1 IPv6 address.
%ipv6 _ 2% xConfiguration Ethernet 2 IP V6 Address Matches the IPv6 address currently
configured on the VCS for LAN 2. Replaces the string with the
LAN 2 IPv6 address.
%localdomains% xConfiguration SIP Domains Domain 1 Name
...
xConfiguration SIP Domains Domain 20 Name Matches all the SIP domains currently
configured on the VCS. not applicable
%localdomain1%
...
%localdomain20% xConfiguration SIP Domains Domain 1 Name
...
xConfiguration SIP Domains Domain 20 Name Matches the specified SIP domain. Up to
20 SIP domains can be configured on the
VCS, and they are identified by an index
number between 1 and 20. Replaces the string with the
specified SIP domain.
%systemname% xConfiguration SystemUnit Name Matches the VCS’s System Name. Replaces the string with the
VCS’s System Name.
Overview Valid Variable Strings