Xconfiguration zones zone [1, Headline text goes here, Command reference - xconfiguration – TANDBERG Security Camera User Manual
Page 212
212
D14049.03
MAY 2008
Grey Headline (continued)
Zones Zone [1..200] TraversalClient H323 Port: <1024..65534>
Specifies the port on the traversal server to be used for H.323 firewall traversal calls from this VCS. If your traversal server is a VCS Expressway, this must be the port number that has been
configured in the Traversal Server zone for this VCS.
Default: 2777
Example:
xConfiguration Zones Zone 2 TraversalClient H323 Port: 2777
Zones Zone [1..200] TraversalClient H323 Protocol:
Determines which of the two firewall traversal protocols will be used for calls to and from the traversal server.
Note: the same protocol must be set on the server for calls to and from this traversal client.
Default: Assent
Example:
xConfiguration Zones Zone 2 TraversalClient H323 Protocol: Assent
Zones Zone [1..200] TraversalClient Primary Address:
Specifies the IP Address or Fully Qualified Domain Name (FQDN) of the traversal server.
Example:
xConfiguration Zones Zone 2 TraversalClient Primary Address: "10.192.168.1"
Zones Zone [1..200] TraversalClient RetryInterval: <1..65534>
Specifies the interval (in seconds) with which a failed attempt to establish a connection to the traversal server should be retried.
Default: 120
Example:
xConfiguration Zones Zone 2 TraversalClient RetryInterval: 120
Zones Zone [1..200] TraversalClient SIP Port: <1024..65534>
Specifies the port on the traversal server to be used for SIP calls from this VCS. If your traversal server is a VCS Expressway, this must be the port number that has been configured in the
Traversal Server zone for this VCS.
Default: 5060
Example:
xConfiguration Zones Zone 2 TraversalClient SIP Port: 5060
Zones Zone [1..200] TraversalClient SIP Transport:
Determines which transport type will be used for SIP calls to and from the traversal server.
Default: TCP
Example:
xConfiguration Zones Zone 2 TraversalClient SIP Transport: TCP
Zones Zone [1..200] TraversalServer Authentication UserName:
The name used by the traversal client when authenticating with the traversal server. If the traversal client is a VCS, this must be the VCS’s Authentication User Name. If the traversal client is
a gatekeeper, this must be the gatekeeper’s System Name.
Example:
xConfiguration Zones Zone 3 TraversalServer Authentication UserName: "User123"
TANDBERG
VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Headline Text Goes Here
Command Reference - xConfiguration