Configuring a traversal client zone, Configuring the vcs as a traversal client – TANDBERG Security Camera User Manual
Page 153
153
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG
VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Configuring the VCS as a Traversal Client
Configuring a Traversal Client Zone
VCS Configuration > Zones
•
.
You will be taken to the
Zones
page.
Click on the name of the zone you wish to
configure.
You will be taken to the
Edit Zone
page.
e [1..200]
e [1..200]
Traversal Client
Retry interval
Specifies the interval in seconds with which a
failed attempt to establish a connection to the
traversal server should be retried.
H.323 mode
Determines whether H.323 calls will be allowed
to and from this zone.
H.323 port
Specifies the port on the traversal server to be
used for H.323 firewall traversal calls.
H.323 protocol
Determines which of the two firewall traversal
protocols to use for calls to the traversal
server.
SIP mode
Determines whether SIP calls will be allowed to
and from this zone.
SIP port
Specifies the port on the traversal server to be
used for SIP calls from this VCS.
SIP transport
Determines which transport type will be used
for SIP calls to and from the traversal server.
Primary address
Specifies the IP address or FQDN of the
traversal server.
Alternate 1..5 Address
Specifies the IP addresses or FQDNs of any
alternates configured on the traversal server.
Remember to
Save
your changes.
Hop count
Specifies the hop count to be used when
querying this zone.
Authentication username
This field displays the Authentication username
that has been configured on this VCS. The
Authentication username and password are
system-wide settings that are used for all
Traversal Client Zones. The Authentication
username cannot be edited directly from this
page but it is shown here for reference as it
is needed when configuring the corresponding
Traversal Server Zone.
To edit the Authentication username, click on
the
Edit Authentication Username/Password
link. This will take you to the
Authentication
page, where you can edit the settings under
the
External Registration Credentials
section.