Xconfiguration zones zone [1, Xconfiguration zones zon, Command reference - xconfiguration – TANDBERG Security Camera User Manual

Page 209

209

D14049.03
MAY 2008

Grey Headline (continued)

Zones LocalZone Traversal H323 UDPProbe RetryInterval: <1..65534>

Sets the frequency (in seconds) with which traversal-enabled endpoints registered directly with the VCS will send a UDP probe to the VCS.
Default: 2

Example:

xConfiguration Zones LocalZone Traversal H323 UDPProbe RetryInterval: 2

Zones LocalZone TraversalSubZone Bandwidth PerCall Limit: <1..100000000>

Specifies the bandwidth limit (in kbps) applied to any one traversal call being handled by the VCS (applies only if Mode is set to Limited).
Default: 1920

Example:

xConfiguration Zones LocalZone TraversalSubZone Bandwidth PerCall Limit: 1920

Zones LocalZone TraversalSubZone Bandwidth PerCall Mode:

Determines whether there is a limit on the bandwidth of any one traversal call being handled by the VCS.

NoBandwidth

: no bandwidth available. No traversal calls can be made.

Default: Unlimited

Example:

xConfiguration Zones LocalZone TraversalSubZone Bandwidth PerCall Mode: Limited

Zones LocalZone TraversalSubZone Bandwidth Total Limit: <1..100000000>

Specifies the total bandwidth (in kbps) allowed for all traversal calls being handled by the VCS (applies only if Mode is set to Limited).
Default: 500000

Example:

xConfiguration Zones LocalZone TraversalSubZone Bandwidth Total Limit: 500000

Zones LocalZone TraversalSubZone Bandwidth Total Mode:

Determines whether or not there is a limit to the total bandwidth of all traversal calls being handled by the VCS.

NoBandwidth

: no bandwidth available. No traversal calls can be made.

Default: Unlimited

Example:

xConfiguration Zones LocalZone TraversalSubZone Bandwidth Total Mode: Limited

Zones Zone [1..200] ENUM DNSSuffix:

Specifies the DNS zone to be appended to the transformed E.164 number to create an ENUM host name which this zone is then queried for.

Example: