TANDBERG Security Camera - Manual (Page 221)

221
D14049.03
MAY 2008
Grey Headline (continued)
LinkAdd
Adds and configures a new link.
LinkName (r) :
Assigns a name to this link.
Node1:
Specifies the first zone or subzone to which this link will be applied.
Node2:
Specifies the second zone or subzone to which this link will be applied.
Pipe1:
Specifies the first pipe to be associated with this link.
Pipe2:
Specifies the second pipe to be associated with this link.
Example: xCommand LinkAdd LinkName: "Subzone1 to UK" Node1: "Subzone1" Node2: "UK Sales Office" Pipe1: "512Kb ASDL"
LinkDelete
Deletes a link.
LinkId (r) : <1..600>
The index of the link to be deleted.
Example: xCommand LinkDelete LinkId: 2
Locate
Runs the VCS's location algorithm to locate the endpoint identified by the given alias, searching locally, on neighbors, and on systems discovered through the DNS system, within the
specified number of 'hops'. Results are reported back through the xFeedback mechanism, which must therefore be activated before issuing this command (e.g.
xFeedback register
event/locate ).
Alias (r) :
The alias associated with the endpoint you wish to locate.
HopCount (r) : <0..255>
The hop count to be used in the search.
Protocol (r) :
The protocol used to initiate the search.
Example: xCommand Locate Alias: "[email protected]" HopCount: 15 Protocol: SIP
OptionKeyAdd
Adds a new option key to the VCS. These are added to the VCS in order to add extra functionality, such as increasing the VCS's capacity. Contact your TANDBERG representative for further
information.
Key (r) :
Specifies the option key of your software option.
Example: xCommand OptionKeyAdd Key: "1X4757T5-1-60BAD5CD"
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Command Reference - xCommand