TANDBERG Security Camera - Manual (Page 138)

138
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Links
Automatically Created Links
Whenever a new subzone or zone is created, links are
automatically created as follows:
New zone/subzone type Default links are created to...
Subzone Default Subzone and
Traversal Subzone
Neighbor zone Default Subzone and
Traversal Subzone
DNS Zone Default Subzone and
Traversal Subzone
ENUM Zone Default Subzone and
Traversal Subzone
Traversal Client Zone Traversal Subzone
Traversal Server Zone Traversal Subzone
Default Links
!
Calls will fail if links are not configured correctly. You
can check whether a call will succeed, and what
bandwidth will be allocated to it, using the command
xCommand CheckBandwidth .
Pre-Configured Links
The VCS is shipped with the Default Subzone, Traversal Subzone
and Default Zone already created, and with links pre-configured
between the three. You may delete or amend these default links
if you need to model restrictions of your network.
If any of these links have been deleted, they may all be
automatically restored via:
xCommand DefaultLinksAdd •
To restore these links via the web interface, you must do so
manually. See
Creating Links for instructions on how to do this.
About Default Links
If a subzone has no links configured, then endpoints within the
subzone will only be able to call other endpoints within the same
subzone. For this reason, the VCS comes shipped with a set of
pre-configured links and will also automatically create new links
each time you create a new subzone.
You can edit any of these default links in the same way
you would edit manually configured links. See
Editing
Links for more information.