Configuring the vcs as a traversal server, Overview, Adding a new traversal server zone – TANDBERG Security Camera User Manual
Page 154: Overview adding a new traversal server zone
154
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG
VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Configuring the VCS as a Traversal Server
Overview
The VCS Expressway can act as a firewall
traversal server. This feature means you can:
Allow your VCS to act as a traversal server
•
for other VCSs and TANDBERG Gatekeepers.
You do this by adding a new traversal server
zone on the VCS, and configuring it with
details of the traversal client.
Provide firewall traversal for any traversal-
•
enabled endpoints (i.e. TANDBERG MXP
endpoints and any other endpoints that
support the ITU H.460.18 and H.460.19
standards) registered directly with it. You
can configure the protocols and ports that
will be used.
Enable and configure STUN services.
•
Configure the ports used specifically for
•
firewall traversal services.
The following sections describe how to
configure each of the above options.
VCS Configuration > Zones
•
.
You will be taken to the
Zones
page.
Select
New
.
You will be taken to the
Create Zone
page.
Name
Enter the name you wish to give to this zone.
The name acts as a unique identifier, allowing
you to distinguish between zones.
Type
From the
Type
drop-down menu, select
TraversalServer
.
Create Zone
Click here to create the zone. You will be taken
directly to the
Edit Zone
page, where you can
configure the traversal server zone as required.
Adding a New Traversal Server Zone