TANDBERG Security Camera - Manual (Page 216)

216
D14049.03
MAY 2008
Grey Headline (continued)
AllowListAdd
Adds an entry to the Allow List.
PatternString (r) :
Specifies an entry to be added to the Allow List. If one of an endpoint's aliases matches one of the patterns in the Allow List, the registration will be permitted.
PatternType:
Specifies whether the entry in the Allow List is a prefix, suffix, regular expression, or must be matched exactly.
Example: xCommand AllowListAdd PatternString: "[email protected]" PatternType: Exact
AllowListDelete
Deletes an entry from the Allow List.
AllowListId (r) : <1..2500>
The index of the entry to be deleted.
Example: xCommand AllowListDelete AllowListId: 2
Boot
Restarts the VCS.
This command has no parameters.
Example: xCommand boot
CheckBandwidth
A diagnostic tool that returns the status and route (as a list of nodes and links) that a call of the specified type and bandwidth would take between two nodes. Note that this command does
not change any existing system configuration.
Node1 (r) :
The subzone or zone from which the call originates.
Node2 (r) :
The subzone or zone at which the call terminates.
Bandwidth (r) : <1..100000000>
The requested bandwidth of the call (in kbps).
CallType (r) :
Whether the call type is Traversal or Non Traversal.
Example: xCommand CheckBandwidth Node1: "DefaultSubzone" Node2: "UK Sales Office" Bandwidth: 512 CallType: nontraversal
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Command Reference - xCommand