TANDBERG Security Camera - Manual (Page 170)

170
D14049.03
MAY 2008
Grey Headline (continued)
TANDBERG VIDEO COMMUNICATIONS SERVER
ADMINISTRATOR GUIDE
Introduction Getting Started
Overview and
Status
System
Configuration
VCS
Configuration
Zones and
Neighbors
Call
Processing
Bandwidth
Control
Firewall
Traversal
Maintenance Appendices
Restoring Default Configuration
DefaultValuesSet Level 3
It is possible to restore the VCS to its default configuration. This
is done via the CLI using
xCommand DefaultValuesSet . This
command is not available via the web UI.
The
DefaultValuesSet command allows you to specify the
level of configuration to restore, from 1 to 3 as follows:
Level 1 • resets most configuration items to their default value,
with the exception of the items shown in the table opposite.
The
xConfiguration reference table shows a full list of all
configuration items and where applicable their default values.
Level 2 • is not currently used, so setting this level has the
same effect as setting Level 1.
Level 3 • resets all configuration items to their default value,
including those shown in the table opposite.
Configuration item Default value after xCommand DefaultValuesSet Level: 3
SystemUnit Name
SystemUnit Password TANDBERG
Option [1..64] Key
IPProtocol IPv4
IP Gateway 127.0.0.1
IP V6 Gateway
IP DNS Server [1..5] Address
IP DNS Domain Name
Ethernet [1..2] Speed Auto
Ethernet [1..2] IP V4 Address 192.168.0.100
Ethernet [1..2] IP V4 SubnetMask 255.255.255.0
Ethernet [1..2] IP V6 Address
NTP Address
SNMP Mode On
SNMP CommunityName public
SNMP SystemContact
SNMP SystemLocation
Administration TimeOut 0
ExternalManager Address
ExternalManager Path tms/public/external/management/SystemManagementService.asmx
Policy AdministratorPolicy Mode Off
Policy UserPolicy Mode Local
Policy UserPolicy Server Protocol HTTP
Policy UserPolicy Server Address
Policy UserPolicy Server Path
Policy UserPolicy Server UserName
Policy UserPolicy Server Password
Overview
! xCommand DefaultValuesSet Level: 3 must be
used with caution, as it resets the system’s IPv4 and
IPv6 addresses, meaning you will no longer be able to
access the system over IP. It also deletes all option keys
including pre-installed options such as Expressway and the
number of registrations and calls.