Roland Fantom-Xa - Manual (Page 73)

73
Creating a Performance
1. Make sure that the performance you wish to save is
selected.
2. Press [WRITE].
The WRITE MENU screen appears.
fig.PfmWrite
3. Press [F1 (PERF)].
* Alternatively, you can use or to select “Performance,” and
then press [ENTER].
The PERFORMANCE NAME screen appears.
fig.PfmName
4. Assign a name to the performance.
For details on assigning names, refer to Assigning a Name (p.
28).
5. When you have finished inputting the name, press [F6
(WRITE)].
A screen will appear, allowing you to select the write-
destination performance.
6. Use the VALUE dial, [INC] [DEC], or and [F1
(USER)] [F2 (CARD)] to select the write destination and
rhythm set number.
7. Press [F6 (WRITE)].
A message will ask you for confirmation.
8. Press [F6 (EXEC)] to execute the save operation.
* To cancel, press [F5 (CANCEL)].
Never switch off the Fantom-Xa while data is being saved.
When Changing the Settings for the
Patch or Rhythm Set Assigned to a
Part in a Performance
If you’ve edited a patch or rhythm set assigned to a part in a
performance and then try to save the performance without first
saving the edited patch or rhythm set, the following message
appears.
fig.PfmWrite2
In such cases, first save the patches and rhythm sets, and then save
the performance.
[F1 (PATCH)]
* When the cursor is at a Type, Group, or Number, you can press
[ENTER] to open the PATCH LIST screen and choose a patch from
the list (p. 30).
[F2 (LVL PAN)]
Functions of Parameters of
Each Part
(Performance Parameters)
Parameter Value Explanation
Type Patch, Rhythm Sets the assignment of a patch
(Patch) or rhythm set (Rhythm)
to each of the parts.
Group USER, PR-A–F,
GM, CARD,
EXP Selects the group to which the
desired patch or rhythm set be-
longs.
USER: User
PR-A–F: Preset A–F
GM: GM (GM2)
CARD: Card
EXP: Wave Expansion Board
Number 001–**** Selects the desired patch or
rhythm set by its number.
Parameter Value Explanation
Level 0–127 Volume of each part
This setting’s main purpose is to
adjust the volume balance be-
tween parts.
Pan L64–0–63R Left/right position of each part
Kbd OFF, ON
(
✔ )
Specifies, for each part, whether or
not the keyboard controller section
will be connected to the internal
sound generator.
Solo OFF, ON
(
✔ )
Check “ ✔ ” this setting if you want to
hear the part by itself; this is called
“soloing” the part.
Mute OFF, ON
(
✔ )
Mutes ( ✔ ) or un-mutes (OFF) each
part.
Use this setting when, for exam-
ple, you want to use the instru-
ment for karaoke by muting the
part playing the melody, or when
you want to play something using
a separate sound module.
* The Mute Switch parameter does not
turn the part off, but sets the volume
to minimum so that no sound is
heard. Therefore, MIDI messages are
still received.
Fantom-Xa_e.book 73 ページ ２００４年１０月２２日 金曜日 午後２時３分