Output assign parameters (p. 159), P. 159), 159 adding effects – Roland Fantom-Xa User Manual
Page 159
159
Adding Effects
MFX Reverb
Send Level
0–127
Amount of reverb for the sound passed through multi-effects
Chorus Source
KBD, PAD
Chorus parameter settings
KBD:
Settings of the patch or rhythm set assigned to the Keyboard part
PAD:
Settings of the patch or rhythm set assigned to the Pad part
Chorus Type
0–3
Selects either chorus or delay.
0 (OFF):
Neither chorus or delay is used.
1 (CHORUS):
Chorus is used.
2 (DELAY):
Delay is used.
3 (GM2 CHO):
General MIDI 2 chorus
Reverb Source
KBD, PAD
Reverb parameter settings
KBD:
Settings of the patch or rhythm set assigned to the Keyboard part
PAD:
Settings of the patch or rhythm set assigned to the Pad part
Reverb Type
0–5
Type of reverb
0 (OFF):
Reverb is not used.
1 (REVERB):
Normal reverb
2 (SRV ROOM):
Simulates typical room acoustic reflections.
3 (SRV HALL):
Simulates typical concert hall acoustic reflections.
4 (SRV PLATE):
Simulates a plate reverb, a popular type of artificial reverb unit that derives its
sound from the vibration of a metallic plate.
5 (GM2 REV):
General MIDI 2 reverb
MFX Output
Assign
A, B
Output destination of the sound passed through the multi-effects
A:
OUTPUT A (MIX) jacks in stereo
B:
OUTPUT B jacks in stereo
* If the Mix/Parallel parameter is set to “MIX,” all sounds are output from the OUTPUT A (MIX) jacks in
Chorus Out-
put Select
MAIN, REV,
M+R
Specifies how the sound routed through chorus will be output.
MAIN:
Output to the OUTPUT jacks in stereo.
REV:
Output to reverb in mono.
M+R:
Output to the OUTPUT jacks in stereo, and to reverb in mono.
Chorus Level
0–127
Volume of the sound passed through chorus
Chorus Out-
put Assign
A, B
Selects the pair of OUTPUT jacks to which the chorus sound is routed when Chorus Output Select is
set to “MAIN” or “M+R.”
A:
Output to the OUTPUT A (MIX) jacks in stereo.
B:
Output to the OUTPUT B jacks in stereo.
* When Chorus Output Select is set to “REV,” this setting will have no effect.
Reverb Level
0–127
Volume of the sound passed through reverb
Reverb Output
Assign
A, B
Specifies how the sound routed through reverb will be output.
A:
Output to the OUTPUT A (MIX) jacks in stereo.
B:
Output to the OUTPUT B jacks in stereo.
* If the Mix/Parallel parameter is set to “MIX,” all sounds are output from the OUTPUT A (MIX) jacks in
Mastering Ef-
fect Type
0–5
Mastering effect settings
Parameter
Value
Explanation
9
10
11
12
13
14
15
Fantom-Xa_e.book 159 ページ ２００４年１０月２２日 金曜日 午後２時３分