beautypg.com

Turning on/off the power, Turning off the power, Adjusting the display contrast (lcd contrast) – Roland Fantom-Xa User Manual

Page 16: The ac adaptor from the outlet (p. 16), Output a (mix) jacks and phones jack (p. 16), Setting screen (p. 16), Press to turn the power on/off (p. 16), 16 getting ready

background image

16

Getting Ready

941

*

Once the connections have been completed (p. 15), turn on power to
your various devices in the order specified. By turning on devices in
the wrong order, you risk causing malfunction and/or damage to
speakers and other devices.

1.

Before turning on the Fantom-Xa’s power, consider these

two questions:

• Are all devices connected properly?

• Have the volume controls of the Fantom-Xa and all connected

audio devices been turned to their lowest settings?

2.

Turn on the POWER ON switch located on the rear panel of

the Fantom-Xa.

fig.PowerOn

942

*

This unit is equipped with a protection circuit. A brief interval (a few
seconds) after power up is required before the unit will operate
normally.

*

To ensure proper operation of the pitch bend lever, make sure not to
touch the lever when turning the Fantom-Xa’s power on.

3.

Turn on the power for any connected audio devices.

4.

While playing the keyboard, gradually raise the volume of

the Fantom-Xa and connected devices.

fig.Volume

1.

Before turning off the power, consider these two questions:

• Have the volume controls of the Fantom-Xa and all connected

audio devices been turned to their lowest settings?

• Have you saved your Fantom-Xa sounds or other data you’ve

created?

2.

Turn off the power for all connected audio devices.

3.

Turn off the POWER ON switch of the Fantom-Xa.

The characters in the display may be difficult to view immediately
after turning on the Fantom-Xa’s power or after extended use. Your
viewing angle or the current lighting conditions can also affect the
appearance of the display. In such situations, adjust the contrast of
the display.

1.

Hold down [SHIFT] and press [PAGE] to open the LCD

Contrast window.

2.

Turn the VALUE dial to adjust the contrast.

*

If you want to keep the contrast of the display, save the setting in
internal system memory (p. 192).

Turning On/Off the Power

Do not touch!

Turning Off the Power

Adjusting the Display
Contrast (LCD Contrast)

Fantom-Xa_e.book 16 ページ 2004年10月22日 金曜日 午後2時3分