Roland Fantom-Xa - Manual (Page 42)

42
Creating a Patch
[F5 (KEY RNG)] (TMT KEY RANGE)
You can use the note number to control the way each Tone is played.
fig.TMT-K.e
[F6 (VEL RNG)] (TMT VELO RANGE)
You can use the force with which keys are played to control the way each Tone is played.
fig.TMT-V.e
When using the Matrix Control to have different tones played, set the lowest value (Lower) and highest value (Upper) of the value of the
MIDI message used.
Instead of using Velocity, you can also have tones substituted using the Matrix Control (p. 49). However, the keyboard velocity and the
Matrix Control cannot be used simultaneously to make different tones to sound. When using the Matrix Control to switch tones, set the Tone
Mix Velo Control parameter to “OFF.”
Parameter Value Explanation
Key Fade Lower 0–127 Determines what will happen to the tone’s level when a note that’s lower than Key Range Lower is
played.
If you don’t want the tone to sound at all, set this parameter to “0.”
Key Range Lower C - –(Upper) Specifies the lowest note that the tone will sound for each tone.
Key Range Upper (Lower)–G9 Specifies the highest note that the tone will sound for each tone.
Key Fade Upper 0–127 Determines what will happen to the tone’s level when a note that’s higher than Key Range Upper is
played.
If you don’t want the tone to sound at all, set this parameter to “0.”
Parameter Value Explanation
Tone Mix Velo
Control OFF, ON,
RANDOM,
CYCLE Determines whether a different tone is played (ON) or not (OFF) depending on the force with which the
key is played (velocity).
RANDOM: The patch’s constituent tones will sound randomly, regardless of any Velocity messages.
CYCLE: The patch’s constituent tones will sound consecutively, regardless of any Velocity messages.
Control Switch OFF, ON Use the Matrix Control (p. 49) to enable (ON), or disable (OFF) sounding of different tones.
Velo Fade Lower 0–127 Determines what will happen to the tone’s level when the tone is played at a velocity lower than Velo
Range Lower.
If you don’t want the tone to sound at all, set this parameter to “0.”
Velo Range Lower 1–(Upper) Specifies the lowest velocity at which the tone will sound.
Velo Range Upper (Lower)–127 Specifies the highest velocity at which the tone will sound.
Velo Fade Upper 0–127 Determines what will happen to the tone’s level when the tone is played at a velocity greater than Velo
Range Upper.
If you don’t want the tone to sound at all, set this parameter to “0.”
Key Range Lower Key Range Upper
Key Fade Lower Key Fade Upper
Level
The tone sounded
in the lower range The tone sounded
in the upper range
Pitch
Velo Range Lower Velo Range Upper
Velo Fade Lower Velo Fade Upper
Level
The tone sounded
when you play softly The tone sounded
when you play strongly
Velocity
Fantom-Xa_e.book 42 ページ ２００４年１０月２２日 金曜日 午後２時３分