Nortel Networks Call Center Telephone - Manual (Page 87)

Chapter 7 Off-premise Message Notification 87
Call Center Telephone Administration Guide
9 Press OK or £ to accept the start time.
10 Enter the time when Off-premise Message Notification is to stop.
This is a four digit field. Any single digit hour and minute must be
preceded by a zero.
11 Press AM or ⁄
or
PM or ¤.
12 Press OK or £ to accept the stop time.
13 Press YES or ⁄ to set up another destination number.
14 Press SETUP to set up another destination number.
15 Press PAGER or ‹ to select a pager number destination.
16 Enter the destination pager number and press OK or £.
17 Press OK or £ to accept the destination pager number represented
by
or
press ADD or ¤ to add special characters and use your dialpad or
follow the voice prompts to add characters.
After you add special characters, press OK or £.
18 Press NEXT or £ to accept the default pager message represented
by . The default pager message sent by CallPilot is the
CallPilot extension. This is the sequence of digits that is sent after
the pager service is dialed, to notify you of who is paging you
or
press CHNG or ⁄ to change the pager message.
The combined limit is 30 characters for the pager telephone
number and the pager message.
19 The display shows that the second destination is a pager.
Press NEXT or £ to continue.
20 Press NEXT or £ to continue
or
press SETUP to add another destination.
RETRY OK
Stop hhmm:
RETRY OK
RETRY AM PM
RETRY OK
More dest?
YES NO
Notify2: none
SETUP NEXT
Destination:
PHONE EXT PAGER
Pager:
RETRY OK
ADD OK
Show
CHNG NEXT
Notify2: pager
CHNG OTHR NEXT
Notify 3: none
SETUP NEXT