Paradyne 9788 - Manual (Page 289)

C. Router CLI Commands, Codes, and Designations
9700-A2-GB20-20 December 2002 C-25
Show Commands
Show commands allow you to display information.
Table C-13. Show Commands (1 of 4)
show arp
Minimum Access Level: Operator
Command Mode: Standard
Displays the devices in the ARP table.
The general format of the show arp command is:
The first column displays the IP address. The second column displays the actual time left
for the specific entry, or “STATIC” for configured static entries. The third column displays
the MAC address for the ARP entry. The fourth column displays the ARP type (only ARPA
is currently supported). The fifth column displays the Interface or sub-interface for the
ARP table entry.
show bridge
Minimum Access Level: Operator
Command Mode: Standard
Displays entries in the bridge forwarding database.
show configuration
Minimum Access Level: Operator
Command Mode: Standard
Displays/outputs a sequence of commands in the form of ASCII strings that have the
effect of setting all configurable parameters to the current values in memory.
Passwords are write-only and not output. The text file can be used with a terminal
emulation program. Refer to
Configuring the Router Using Terminal Emulation in
Chapter 5, Configuring the FrameSaver DSL Router.
The general format of the show config command is:
global commands
!
interface n
interface n commands....
!
interface n sub-interface n
interface n sub-interface n commands...
!
interface n sub-interface n+1
interface n sub-interface n+1 commands...
interface n+1
IP Address Timeout (min) MAC address Type Interface
x.x.x.x STATIC xx:xx:xx:xx:xx:xx ARPA
x.x.x.x time xx:xx:xx:xx:xx:xx ARPA Interface