Ip ping test – procedure 1, Ip ping test, Procedure 1 – Paradyne 9788 User Manual
Page 212
8. Troubleshooting
8-28
December
2002
9700-A2-GB20-20
IP Ping Test – Procedure 1
Procedure
To ping any far-end FrameSaver device:
1. Select the IP Ping test.
Main Menu
→Test→IP Ping
2. Enter the IP Address to ping, then select Start.
NOTE:
If the FrameSaver unit or the far-end unit has just initialized, it may take
about a minute for the units to learn the routes via the proprietary RIP.
3. Verify the results of the IP Ping test.
— While the test is running, In Progress appears in the Status field.
— When the test is finished, Alive should appear as the Status. If any other
message is displayed, additional testing is required.