Paradyne 9788 - Manual (Page 101)

4. Configuration Options
9700-A2-GB20-20 December 2002 4-61
Inactivity Timeout
Possible Settings: Enable, Disable
Default Setting: Enable
Determines whether a user session is disconnected after a specified time of inactivity (no
keyboard activity).
Display Conditions – This option appears only when Port Use is set to Terminal.
Enable – Disconnects user session after the specified time of inactivity (next option).
Disable – Does not timeout and disconnect user session.
Disconnect Time (Minutes)
Possible Settings: 1 – 60
Default Setting: 10
Sets the number of minutes of inactivity that can elapse before the session is ended.
Display Conditions – This option appears only when Port Use is set to Terminal.
1 – 60 – Sets the time from 1 to 60 minutes.
IP Address
Possible Settings: 001.000.000.000–126.255.255.255,
128.000.000.000–223.255.255.255, Clear
Default Setting: Clear (000.000.000.000)
Specifies a unique IP address for accessing the unit via the COM port. This option is only
in effect when the COM port is configured as a network communication link
(Port Use option is set to Net Link).
Display Conditions – This option appears only when Port Use is set to Net Link.
001.000.000.000 – 223.255.255.255 – Shows the IP address for the COM port, which you
can view or edit. The first octet of the address cannot be decimal 0 or 127, or greater than
223.
Clear – Clears the IP address for the COM port and fills the address with zeros. When the
IP Address is all zeros, the COM port uses the Node IP Address if one has been
configured.
Subnet Mask
Possible Settings: 000.000.000.000 – 255.255.255.255, Clear
Default Setting: 000.000.000.000
Specifies the subnet mask needed to access the unit. Only in effect when the COM port is
configured as a network communication link (Port Use option is set to Net Link).
Display Conditions – This option appears only when Port Use is set to Net Link.
000.000.000.000 – 255.255.255.255 – Shows COM port subnet mask, which you can
view or edit.
Clear – Clears the subnet mask for the COM port and fills the address with zeros. When
the node subnet mask is all zeros, the IP protocol creates a default subnet mask based
upon the IP address class: Class A: 255.000.000.000, Class B: 255.255.000.000, or
Class C: 255.255.255.000.
Table 4-25. Communication Port Options (3 of 4)