Paradyne 9788 - Manual (Page 156)

7. Operation and Maintenance
7-20 December 2002 9700-A2-GB20-20
Health and Status Messages
Table 7-6, Health and Status Messages , provides Health and Status messages
that apply to the FrameSaver unit.
Table 7-6. Health and Status Messages (1 of 2)
Message What It Indicates
Back-to-Back Mode Active The unit has been configured for back-to-back
operation.
Main Menu → Control →Change Operating Mode
The FrameSaver unit can be connected to another
FrameSaver unit without a frame relay switch between
them. This feature is useful for product demonstrations
or for a point-to-point configuration using a leased line.
COS x Down, PathIP_ Address,
InterfaceDLCInnnn
A Class Of Service associated with a path is down.
COS
x is the Class of Service ID associated with the
path, IP_Address is the IP address of the path endpoint,
Interface is P1 (Port 1) or N1 (Network 1), and nnnn is
the DLCI which contains the path.
CTS down to Port 1 Device
(CSU/DSU only)
The CSU/DSU’s user data port CTS control lead is off.
DLCI nnnn Down, Port 1 The DLCI for the Port 1 frame relay link is down.
DSL Line Training, Network 1 The device is in the process of determining the right
speed.
DTR Down from Port 1 Device
(CSU/DSU only)
The device DTR control lead connected to the user data
port is deasserted.
Ethernet Mgmt Down The Ethernet management interface is down. The port
is enabled and is the primary interface for management
data, but communication between the management
system and the unit is not currently possible.
Ethernet Port Down The Ethernet link is down. The port is enabled and is
the primary interface for user data, but communication
between the unit and the far end is not currently
possible.
Latency IP_ Address,
COS x,InterfaceDLCInnnn 1
An IP SLV Latency Threshold has been exceeded for
the specified COS of the Path.
IP_Address is the IP
address of the path endpoint, COS x is the Class of
Service ID associated with the path, Interface is P1
(Port 1) or N1 (Network 1), and nnnn is the DLCI which
contains the path.
Link Down Administratively,
Port 1 CSU/DSU only. The specified frame relay link has been
disabled by the unit due to LMI Behavior conditions or
LMI Protocol on another link is in a failed state.
This is not an alarm condition so System
Operational
appears as well.