Paradyne 9788 - Manual (Page 226)

10. Setting Up Network Health for FrameSaver Device
10-2 December 2002 9700-A2-GB20-20
Installation and Setup of Network Health
Refer to the Network Health Installation Guide for installation instructions
applicable to your network platform. Once Network Health is installed, the
application must be configured to support FrameSaver devices.
Each Network Health application provides a different set of functions, called a
module. Each module used requires a separate license to gain access to those
features and functions. Make sure you license the Poller application so you can
poll FrameSaver devices and collect data.
Procedure
To use the Network Health application:
1. Discover network elements, units, and interfaces in the network.
2. Configure the Network Health applications, and save them.
3. Organize elements into groups for reporting purposes.
4. Set up and run reports.
Setup and operation information is contained in the Network Health User Guide.
The sections that follow address only the minimal procedural steps needed once
you have access to the applications.
See the Network Health User and Reports Guides for additional startup
information and a full discussion of the application’s features and how to use them.