Paradyne 9788 - Manual (Page 126)

6. Security and Logins
6-4 December 2002 9700-A2-GB20-20
Controlling External COM Port Device Access
Dial-in access to the user interface can be controlled when an external device
(modem) is connected to the unit’s COM port. The External Device Commands
option must be set to AT.
Procedure
To control dial-in access:
1. Select the External Modem options.
Main Menu
→Configuration→Management and Communication→
External Modem (Com Port)
2. Enable the Dial-In Access configuration option.
This option appears only when the External Device Commands option is set to
AT.
3. Save your changes.
See Configuring the COM Port to Support an External Modem in Chapter 4,
Configuration Options, for more information about external device communication
port configuration options.
Controlling Telnet and FTP Access
The FrameSaver unit provides several methods for limiting access to the user
interface via a Telnet and/or FTP session. Telnet or FTP access can be via a
standard management link or a service provider’s TS (Troubleshooting)
management link. For details regarding Telnet access to the Command Line
Interface, refer to
Controlling Router CLI Access on page 6-11.