Paradyne 3161 User Manual
Page 67
4. Configuration
3160-A2-GB24-10
March 2001
4-13
Configuring the COM Port or Modem Port for SNMP or
Telnet Access
To configure the COM port or Modem port for SNMP or Telnet access:
T
Enable the SNMP agent or Telnet server within the DSU/CSU (see
Appendix C, Configuration Options
T
Select and configure the port that provides the link to the SNMP or Telnet
system.
T
Set the Internet Protocol (IP) address and subnet mask needed to access the
DSU/CSU (see
Appendix G, IP Network Addressing Scenarios
T
Select the link layer protocol (PPP or SLIP) for the port that provides the link to
the SNMP or Telnet system.
T
For SNMP links, specify the two community names (and their access levels)
that are allowed to access the device’s Management Information Base (MIB).
T
For SNMP links, configure the device to send traps to the SNMP manager, if
desired.
T
Specify the Telnet password or SNMP validation options, if desired (see