Paradyne 3161 - Manual (Page 149)

8. Testing
3160-A2-GB24-10 March 2001 8-11
DTE Loopback (DLB)
The DTE Loopback command (DLB) loops the received signal on the DTE
Drop/Insert (DSX-1) port back to the DTE without change.
Procedure
To perform a DTE loopback:
1. From the top-level menu screen, select Test.
2. From the Test screen, select Lpbk.
3. From the Loopback screen, press the key until the DLB selection appears
on the screen.
4. Select DLB.
Test Started appears on Line 2. If a DTE loopback is already in progress,
the Already Active message appears. If an invalid combination of
loopbacks is in progress, the error message Invld Test Combo appears
(see Table 8-2, Valid Loopback Combinations , for valid loopback test
combinations).
496-14317-02
CSU DSU
NETWORK
INTERFACE
DTE
(DSX-1)
DLB
PORT 1 PORT 2
ALL 1s
F1 F2 F3
Test:
Rlpbk Lpbk Ptrns
F1 F2 F3
Loopback:
LLB PLB DLB