Paradyne 3161 - Manual (Page 64)

4. Configuration
4-10 March 2001 3160-A2-GB24-10
Setting the 10BaseT Port IP Address
The 10BaseT port IP address (ENET IP Adr on the front panel) is the address
used by the SNMP or Telnet system to access the DSU/CSU through the 10BaseT
port (see
Appendix G, IP Network Addressing Scenarios ).
The example below shows an IP address of 010.155.111.222 being set for the
10BaseT port. You can use the same principles to assign any valid value to each
of the four bytes of the IP address. Valid values are 000–126 and 128–223 for the
first byte, and 000–255 for the remaining bytes.
Procedure
To assign an IP address to the 10BaseT port:
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied into the Edit area by using the
appropriate Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the key until the User selection appears on the
screen.
5. Select User.
6. Press F1 (Next) until the ENET IP Adr configuration option appears.
7. Press F2 (Edit) to edit the IP address. You have the option of using F3 (Clear)
to reset the IP address to the factory default 000.000.000.000.
8. Use the and keys to position the cursor under the digit you want to
change. Press F1 (Up) to increment the digit or F2 (Down) to decrement the
digit. For example, press
once to place the cursor under the middle digit in
the first byte field, then press F1 (Up) once to change the 0 to a 1. Continue in
this manner to change the other digits.
F1 F2 F3
Edit:
User Alarm Mgmt
F1 F2 F3
ENET IP Adr:
Next Edit Clear
F1 F2 F3
010.000.000.000
Up Down Save