Paradyne 3161 User Manual
Page 193
C. Configuration Options
3160-A2-GB24-10
March 2001
C-27
ENET IP Adr: 000.000.000.000
Next Edit Clear Prev
Ethernet Port IP Address. Specifies the IP address for the 10BaseT port.
Edit – Allows you to edit or display the IP address for the 10BaseT port.
Clear – Allows you to clear the IP address for the 10BaseT port. The IP address is set to
000.000.000.000.
NOTE: This configuration option is not displayed if 10BaseT port use (ENET Use) is
disabled. It is available on Model 3160 and 3165 DSU/CSUs only.
●
ENET NetMask: 000.000.000.000
Next Edit Clear Prev
Subnet Mask for the Ethernet Port. Specifies the subnet mask for the 10BaseT port.
Edit – Allows you to edit and/or display the subnet mask for the 10BaseT port.
Clear – Allows you to clear the subnet mask for the 10BaseT port. The subnet mask is set
to 000.000.000.000. If the subnet mask is 000.000.000.000, the IP protocol creates a
default subnet mask based on the class of the IP address (Class A: 255.000.000.000,
Class B: 255.255.000.000, or Class C: 255.255.255.000).
NOTE: This configuration option is not displayed if 10BaseT port use (ENET Use) is
disabled. It is available on Model 3160 and 3165 DSU/CSUs only.
●
DefGatewayAdr: 000.000.000.000
Next Edit Clear Prev
Default Gateway Address. Specifies the address where messages for other subnets are
sent.
Edit – Allows you to edit and/or display the default gateway address.
Clear – Allows you to clear the default gateway address. The address is set to
000.000.000.000.
NOTE: This configuration option is not displayed if 10BaseT port use (ENET Use) is
disabled. It is available on Model 3160 and 3165 DSU/CSUs only.
●
TnSession: Disab
Next Enab Disab Prev
Telnet Session Enable. Specifies whether the DSU/CSU responds to Telnet session
requests.
Enab – The DSU/CSU responds to Telnet session requests.
Disab – The DSU/CSU does not respond to Telnet session requests.
TnPaswd: Disab
Next Enab Disab Prev
Telnet Password Mode. Specifies whether a password is required for Telnet access.
Enab – A password is required for Telnet access.
Disab – A password is not required for Telnet access.
Table C-7.
User Interface Configuration Options (10 of 11)