Perle Systems RIO 5500036-17 - Manual (Page 89)

RIO Remote I/O System User Guide
Installing RIO under SCO UnixWare
Page 89
Chapter 2 Installing hardware and software
Removing device drivers and utilities from your system
To remove the RIO device drivers and utilities from your system under SCO UnixWare,
proceed as follows;
1. Login to your system as root.
1. At the command prompt, type pkrm rio and then press the Enter key.
2. Re-boot your system.
Creating a login for an RTA
To create a login for an RTA under SCO UnixWare, you use the spxadmport utility. To do
this proceed as follows (this example uses a terminal 9600, 8,1, N on RIO port r001);
1. At the command prompt, type /etc/spxadmport add r001 9600R root and press the
Enter key.
Creation of the login is now complete. For more information about spxadmport , see
spxadmport utility for configuring ports on page 240 in Chapter 4 Quick Reference .