Perle Systems RIO 5500036-17 User Manual
Page 296

RIO Remote I/O System User Guide
SCO UnixWare troubleshooting
Page 296
4. Once you have set all the test parameters you require, press the Enter key to start the
test.
The test now runs and displays the test results window shown in the next picture on
completion.
5. Once you have finished viewing the results of your test press the
Enter
key to return to
the Online Diagnostics menu.
6. Press the
Esc
key to return to the main RIO configuration utility window (
) and
then press the
Esc
key again to exit the utility.
7. If you have finished running port diagnostics you now need to re-enable the port you have
tested.To do this, at the command prompt, type
/etc/spxadmport enable r00x
(when r00x is the port number for example, r001) and press the
Enter
key.
For more information about
spxadmport
spxadmport utility for configuring ports
Hint
If required, you can halt the test by pressing the
Enter
key.