Adding an rta to the system – Perle Systems RIO 5500036-17 User Manual
Page 83
RIO Remote I/O System User Guide
Installing RIO under SCO UnixWare
Page 83
Chapter 2 Installing hardware and software
Adding an RTA to the system
To add an RTA to your system configuration, proceed as follows;
1. Physically install the Remote Terminal Adaptor in your system using the procedures
detailed in
Installing Remote Terminal Adaptors (RTAs)
2. Login to your system as super user.
3. At the command prompt, type
config.rio
and press the
Enter
key.
The RIO configuration utility window is now displayed showing a map of your system. See
Configuring ports with config.rio
for more details about how config.rio
works.
4. In the RIO configuration utility window, highlight the unconfigured RTA you want to add to
the system.
5. Press the
Enter
key.
The RTA Management menu is now displayed.
Note
The way in which an unconfigured RTA is displayed depends on the types of
terminal being used. Normally, either the RTA icon flashes or appears in a
different colour.