Removing an rta from the system – Perle Systems RIO 5500036-17 User Manual
Page 69
RIO Remote I/O System User Guide
Installing RIO under SCO OpenServer 5 and SCO OpenServer 6
Page 69
Chapter 2 Installing hardware and software
Removing an RTA from the system
To remove an RTA from your system configuration, proceed as follows;
1. Physically remove the Remote Terminal Adaptor from your system using the procedures
detailed in
Removing a Remote Terminal Adaptor (RTA)
.
2. Login to your system as super user.
3. At the command prompt, type
config.rio
and press the
Enter
key.
The RIO configuration utility window is now displayed.
4. Press the
Enter
key.
The Main Menu is now displayed.